Skip to main content

Capacity (time) & velocity (points) based planning

Last post 04:01 pm February 12, 2016 by Andrzej Zińczuk
3 replies
11:46 am August 11, 2015

(Scenario 1) Imagine you have a new team with members that have hardly worked together in a scrum team before. Perhaps they are adopting scrum, or that the team has been pulled together from different sources.

As there is no history of velocity and the initial relationship of points to sprint length is going to be volatile for the first few sprints, it would be tempting to switch to capacity based planning where we talk about how much time it will take to execute the tasks as there is a stronger correlation to time taken during the earlier sprints.

(Q1) If capacity based planning is used, would the team still estimate story points in order to establish velocity on hindsight and then subsequently switch over to velocity based planning?

(Scenario 2) With velocity planning where points are awarded to stories which are reviewed in the "What" half of sprint planning, during the "How" part if the team then break down the stories into tasks of a day or less in order that progress can be measured, and they may subsequently re-negociate with the PO on how much they can deliver:

(Q2) ...are they not effectively capacity planning in any case?


09:00 pm August 11, 2015

Development Teams must deliver value, and should therefore be careful to avoid becoming story point accountants.

During Sprint Planning, it's best to look at the forecast of work in aggregate and decide "is the Sprint Goal for this work achievable?". Story points are indicators that can assist the team in making this decision. They are not a method of calculation.

I'd encourage a team from the beginning to take this more holistic view. The forecast of work may be modest until experience is gained; if it proves too conservative then additional work can be brought forward.


06:09 am August 12, 2015

Hi Damian,

For a new Scrum team with no history of velocity, one common way to forecast a team’s velocity is to have the team pull PBIs one by one to determine what PBIs the Team could deliver during a single sprint.

There are 2 way to perform capacity based planning:
1. Estimate how much time it will take to have a PBI be Done.
2. Decompose each PBI to actionable tasks. Estimate how much time it will take to execute the tasks.

The Team could simply add the hour each PBI/task cost and compare to Team’s capacity to determine what PBIs it could commit.

If the forecasting or commitment seems reasonable, the Team could simply add the size of the PBIs pulled to Sprint Backlog and use that as the Team’s forecasted velocity.

There are no switch problem, but using Velocity from now on.

There is a disadvantage by using capacity based planning or idea hour as estimating unit of PBIs.
Image that a PBI’s size is 24 hours in Product Backlog.
The team pull it to Sprint backlog and decompose to 5 Tasks listed as follows:
Task1: 6 hrs.
Task2: 4 hrs.
Task3: 8 hrs.
Task4: 5 hrs.
Task5: 4Hrs

Total: 27 hrs.

There should be a confusing between a PBI and tasks decomposed.

Estimates are not commitments.

For planning purpose, velocity during the “what” part is most useful when expressed as a range. During the “how” part, if the cost is out of range, they may re-negotiate with the PO to remove several item or just start the sprint. Velocity is measured by adding the size of the PBIs that are “COMPLETED” by the end of the sprint. Velocity does not include the size numbers of partially completed PBIs.

As the Team builds up a history of actual velocities, an effective velocity range will be used as a planning tool and as a team diagnostic metric.


04:01 pm February 12, 2016

Each new team starting together has similar issue. To mitigate risk of unknown you can coach team to cut risk horizon and shorten the sprint length to expose to risks and unknown faster. After couple of sprint you will have some kind of feeling what team can forecast during sprint. To minimize the risk during sprint planning you can coach team to slice PBI into multiple small task easier to finish and track - which will in the end reinforce team efforts and improve their morale to get things done.

What kind of knowledge gives unknown velocity prediction in terms of initiative team will try to develop? Is it a try to make sure team is not estimating more than stakeholders assumed it will take?

After each three sprint you will have rolling average to try to predict future.


By posting on our forums you are agreeing to our Terms of Use.

Please note that the first and last name from your Scrum.org member profile will be displayed next to any topic or comment you post on the forums. For privacy concerns, we cannot allow you to post email addresses. All user-submitted content on our Forums may be subject to deletion if it is found to be in violation of our Terms of Use. Scrum.org does not endorse user-submitted content or the content of links to any third-party websites.

Terms of Use

Scrum.org may, at its discretion, remove any post that it deems unsuitable for these forums. Unsuitable post content includes, but is not limited to, Scrum.org Professional-level assessment questions and answers, profanity, insults, racism or sexually explicit content. Using our forum as a platform for the marketing and solicitation of products or services is also prohibited. Forum members who post content deemed unsuitable by Scrum.org may have their access revoked at any time, without warning. Scrum.org may, but is not obliged to, monitor submissions.